Skip to content
Home » Articles » New FOD Bag available from TheCanKey

New FOD Bag available from TheCanKey

    When doing maintenance tasks on an aircraft or helicopter you produce a lot of waste. Safety wire clippings, plastic strip clippings, discarded hardware, sealing bits and pieces and much more. It is up to you to decide if the waste becomes FOD or maybe even dangerous FOD. It all depends on where the waste goes.

    Ideally all the waste should be put in the FOD Can right away. However, it is not all the time practical. You may be working on ladder or stand. Or you simply don’t have a waste can near your work bench.

    Photo: The new TheCanKey FOD Bag.

    So, your waste might end up on the floor, in your pockets, on top of the work bench or it stays in the aircraft or helicopter – “I will get it later.” Now as the waste becomes FOD and is no longer under control. Anything can happen to the FOD. It can become stuck under your shoe and fall off while working on top of a helicopter. Get stuck in a tire. Get sucked into a turbine engine or get stuck in flight or engine controls. Maybe even short electrical terminals.

    It is time to become FOD aware and make sure your waste stays waste and does not become FOD.

    A simple solution is to use the new TheCanKey FOD Bag. It is easy to wear around your waist and clips on/off, when you need it. Keeps your hands free to work. Keeps the FOD out of your pockets and away from the floor.

    The new TheCanKey FOD Bag comes in bright red color with a large white FOD logo to highlight the importance to collect your FOD. It has two separate compartments and adjustable belt.
     
     
    Photo: The new TheCanKey FOD Bag.

    By using TheCanKey FOD Bag you send a strong statement to your mangers, co-workers and others that you take the FOD risk seriously and make and extra effort to collect your FOD.

    FOD awareness should be on every aviation maintenance worker’s mind. The new TheCanKey FOD Bag will keep reminding you of this important message from its place on your work bench or toolbox.